AVer SA series - Manual (Page 208)

200
To Setup Alarm Recording Setting
1. Next to the Start Recording check box, click Detail.
2. In the Alarm Recording Setting dialog box, select the camera to enable/disable video recording.
Enable All to select all cameras.
3. In the Frame Rate selection, select As Setting to record the number of frames based on the
Recording Setting or Max to record the maximum of frames based on the available speed.
4. In the Stop Recording after text box, set the number in second for the program to continue
recording after the alarm has ended.
5. Click OK to accept the new settings and Cancel to exit without saving.
To Setup Alarm SOP
Next to the Alarm SOP check box, click Detail. In the step text boxes, type the standard protocol when
the alarm is activated. When the alarm is activated, the Standard Operation Procedure dialog box will
appear. Just click Next to see the next instruction, Back to see the previous instruction, Finish to end
and Abort to terminate.
To Setup CMS Setting
Next to the Send to CMS check box, click Detail. In the CMS Setting, select the camera to
enable/disable sending the video to CMS. Enable All to select all cameras. Then, click OK to accept
the new settings and Cancel to exit without saving.