AVer SA series - Manual (Page 142)

134
User can select Video size, Frame rate, Video and Quality Mode of camera. And scroll the bar to
adjust the Quality, Brightness, Contrast, Hue, Saturation, and Sharpness of the camera.
 Recording Setting
- Save Original Format: Save the video that is compressed by IP camera’s compress mode.
- Transcode by MPEG4 Encoder: DVR system is decoding the video and compress video
again by using MPEG4 encoder.
 Preview Setting: preview setting will relate to the Save Original Format.
- Decode key frame for Preview: When previewing video, DVR system only shows key frame
and one frame per second.
- Enable live display performance optimization: The live video performance will be optimized
while display.
- Enable update when motion: The video will update only when compare the key frame has
motion found, and then, the video will be displayed.
 Schedule Connect
User can select a certain date and time to connect with IP camera. The blue block means connect
with IP camera and the white block means disconnect with IP camera. Select the connection
status (blue or white) and click the date and time block to set the connection schedule.
 I/O Control: To setup the sensor and relay devices that is installed on IP camera.
 Sensor Setting: To setup sensor that is embedded on the camera.
1. Click the drop-down list and select the sensor ID number.
2. Enter sensor name in Name column
3. The system automatically detects the camera and input relates information. In the Content
section, enter sensor description.
4. In the test section, click Test to check the sensor status. Red is high and Green is low.
5. Click OK to exit and accept the setting and Cancel to exit without saving the setting.