AVer SA series - Manual (Page 71)

63
Network Setting
Configure the network setting (IP address, subnet, DNS, and son on
…) of the system.
- Enable DHCP: To use DHCP server assigning DVR server an IP address.
- Using the following IP address: Assign a fixed IP address for DVR server
- IP ADDRESS: Assign a constant IP address which a real IP addresses give from ISP to DVR
system.
i Do Not assign the DVR to 1.0.0.0 network segment. It will cause the DVR cannot access to
Internet due to the un-recognize to 1.0.0.0 IP segment.
- Mask: It is a bitmask used to identify the sub network and how many bits provide room for host
addresses. Enter the subnet mask of the IP address which user has assigned to DVR system.
- GATEWAY: A network device act as a passageway to internet. Enter the network gateway IP
address
- DNS: Domain Name Server translates domain names (such as www.abb.com.tw) to IP addresses.
Enter the IP address of DNS if it is available.
- Map Network Drive: To add network storage, the Internet storage drive/folder must be mapped as
Network Driver in DVR server. Follow the below steps to map the network drive.
1. Click Map Network Drive button. In the Map Network Drive windows, select the Drive and fill
in the IP address and file folder of file server or NAS on your network in Folder.
2. And then, click Finish to make the connection.
3. After connection successful, user should see the network drive on the Storage Path.
4. To disconnect the mapping network drive, click Disconnect Network Drive.