AVer SA series - Manual (Page 174)

166
- Play Warning Sound
Play alarm sound. To setup click Detail (see also Chapter 4.9.2 ).
- Make Phone Calls
Dial and contact the number in the list. To setup click Detail (see also Chapter 4.9.3 ). To use this
feature, the PC must have a voice modem connected to it. The supported audio system is only
8KHz and 16Bit mono.
- Send E-mail
Send an electronic text message. To setup click Detail (see also Chapter 4.9.4 ).
- File Transmission via FTP
Upload file to remote computer thru FTP (File Transfer Protocol). To setup click Detail (see also
Chapter 4.9.5 ).
- Start Recording
Record the video from the selected camera. To setup click Detail (see also Chapter 4.9.6 ).
- SMS (Short Message Service)/MMS (Multimedia Messaging System)
SMS transmits only text messages to mobile phone. MMS transmits text messages and images
over wireless networks using the wireless application protocol (WAP). Make sure your mobile
phone support this feature and your PC is connected to GSM/GPRS modem. To setup click Detail
(see also
Chapter 4.9.7 ).
- PTZ preset point
Position the PTZ camera based on the preset point setting. To setup click Detail (see also Chapter
4.9.8 ).
- Alarm SOP (Standard Operation Procedure)
List the instructions to inform the person of what to do when the alarm is activated. To setup click
Detail (see also
Chapter 4.9.9 ).
- Send to CMS (Central Management System)
Enable/disable the selected camera to send video to CMS when the alarm is activated (see also
Chapter 4.9.10 )
- Launch Program
To call up the external program that is provided by 3 rd party. Click Detail and click to locate the
program path. Enable Multiple instance check box to allow the program can be executed many
times at the same time.
- Snapshot
Take a snapshot when the alarm is activated.
a. Select Camera: specify which channel video to be snapshot when the alarm is occurred.
 Alarm Camera: when a channel has an alarm occurred, and then, the DVR system will
snapshot the channel video.
 Camera # (1~32): the selected channel would be snapshot when an alarm is occurred.
b. Video Size: select the size of snapshot picture.
c. Number of picture: the number of picture that is going to be taken.