Dynojet 250i: Torque Module - Manual (Page 10)

Torque Module Installation and User Guide for Model 250i Dynamometers
C H A P T E R 1
Load Cell Installation
1-6
6 Remove the six 1/4-inch screws securing the top cover on the dyno and set aside.
Note: Dynojet recommends using a hardened 5/32-inch hex driver (such as Snap-
On FA5E) to remove the 1/4-inch screws. A standard allen key may round off in
the shallow screw head.
7 Remove the cover and set aside.
Figure 1-5: Remove the Top Cover
top cover