Dynojet 250i: Torque Module User Manual
Page 9
Advertising
TO R Q U E M O D U L E I N S T A L L A T I O N
Load Cell Installation
Version 2
Torque Module Installation and User Guide for Model 250i Dynamometers
1-5
3
Using the hand crank or power carriage, unscrew the carriage screw until it is free
from the nut block. Slide the carriage off the dyno.
Figure 1-3: Remove the Carriage
4
Verify the main dyno power is disconnected. Refer to page 1-3 for more
information.
5
Using a 1/2-inch wrench, remove the bolts and washers securing the nut block
and carriage clamps and set aside. Remove the nut block, carriage clamps, and
shims and set aside.
Figure 1-4: Remove the Nut Block, Carriage Clamps, and Shims
hand crank
Advertising