Removing the eddy current brake top cover, Removing the eddy current brake top cover -7 – Dynojet 250i: Torque Module User Manual
Page 11
Advertising
TO R Q U E M O D U L E I N S T A L L A T I O N
Load Cell Installation
Version 2
Torque Module Installation and User Guide for Model 250i Dynamometers
1-7
R
EMOVING
THE
E
DDY
C
URRENT
B
RAKE
T
OP
C
OVER
1
Verify the main dyno power is disconnected. Refer to page 1-3 for more
information.
2
Remove the six screws securing the eddy current brake top cover and set aside.
3
Disconnect the battery ground cable.
Figure 1-6: Remove the Brake Top Cover
brake cover
Advertising