Replacing the dyno top cover and carriage, Replacing the dyno top cover and carriage -17 – Dynojet 250i: Torque Module User Manual
Page 21
Advertising
TO R Q U E M O D U L E I N S T A L L A T I O N
Torque Module Installation
Version 2
Torque Module Installation and User Guide for Model 250i Dynamometers
1-17
R
EPLACING
THE
D
YNO
T
OP
C
OVER
AND
C
ARRIAGE
1
Secure the top cover to the dyno using the six 1/4-inch screws removed earlier.
Note: Dynojet recommends using a hardened 5/32-inch hex driver (such as
Snap-On FA5E) to remove the 1/4-inch screws. A standard allen key may round off
in the shallow screw head.
Figure 1-19: Replace the Top Cover
Advertising