Installing the load cell, Installing the load cell -8 – Dynojet 250i: Torque Module User Manual
Page 12
Advertising
Torque Module Installation and User Guide for Model 250i Dynamometers
C H A P T E R 1
Load Cell Installation
1-8
I
NSTALLING
THE
L
OAD
C
ELL
1
Verify the main dyno power is disconnected. Refer to page 1-3 for more
information.
2
Remove the two bolts and nuts securing the existing bar on the eddy current
brake and remove the bar. Set the bolts and nuts aside.
Figure 1-7: Remove the Existing Bar
bar
Advertising