Installing the torque module, Installing the torque module -12 – Dynojet 250i: Torque Module User Manual
Page 16
Torque Module Installation and User Guide for Model 250i Dynamometers
C H A P T E R 1
Torque Module Installation
1-12
I
NSTALLING
THE
T
ORQUE
M
ODULE
1
Verify the main dyno power is disconnected. Refer to page 1-3 for more
information.
2
Turn off the main power switch on the CPU Module on the dyno electronics and
unplug the power cord.
3
Remove the dust cover from the existing top module.
Figure 1-13: Remove Dust Cover
4
Loosen the top right screw on the back of the existing top module.
5
Plug the Torque Module into the existing top module. Place the dust cover,
removed in step 3, on the Torque Module.
6
Secure the grounding strap on the back of the Air Fuel Module to the existing top
module.
Figure 1-14: Secure Grounding Strap
dust cover
power cord
input
power switch
grounding strap