Dynojet 250i: Torque Module - Manual (Page 24)

Torque Module Installation and User Guide for Model 250i Dynamometers
C H A P T E R 1
Torque Module Installation
1-20
R EPLACING THE E DDY C URRENT B RAKE T OP C OVER
Before replacing the top cover, be sure to calibrate your load cell. Refer to Chapter 2
"Using the Torque Module".
1
Connect the battery ground cable.
2 Secure the eddy current brake top cover using the six bolts removed earlier.
Note: Before replacing the top cover, be sure to calibrate your load cell. Refer to
Chapter 2 "Using the Torque Module".
Figure 1-23: Replace the Brake Top Cover
brake cover