Load cell installation, Removing the carriage and dyno top cover, Removing the carriage and dyno top cover -4 – Dynojet 250i: Torque Module User Manual
Page 8
Advertising
Torque Module Installation and User Guide for Model 250i Dynamometers
C H A P T E R 1
Load Cell Installation
1-4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LOAD CELL INSTALLATION
This section describes how to remove the top covers, install the load cell, and replace
the top covers.
R
EMOVING
THE
C
ARRIAGE
AND
D
YNO
T
OP
C
OVER
You will need to remove the tire carriage and top cover in order to route the load cell
cable to the dyno electronics.
1
Using a 5/32-inch allen wrench, remove the two button-head screws securing the
carriage screw support bracket and set aside.
2
Remove the support bracket and set aside.
Figure 1-2: Remove the Support Bracket
screws
support
bracket
carriage screw
belleville washers
Advertising