Dynojet 250i: Torque Module User Manual
Page 15
Advertising
TO R Q U E M O D U L E I N S T A L L A T I O N
Torque Module Installation
Version 2
Torque Module Installation and User Guide for Model 250i Dynamometers
1-11
4
Remove the twelve screws securing the cover and lift the cover off.
Figure 1-11: Remove Electronics Enclosure Cover
5
Add the torque module to the top of the dyno electronics. Refer to “Installing the
Torque Module” on page 1-12.
6
Leave the dyno electronics enclosure out. You will need to route the load cell
cable to the Torque Module later.
Figure 1-12: Inside the Electronics Enclosure
dyno electronics
Advertising