Dynojet 424xLC2: Installation Guide - Manual (Page 107)

4-11
E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Eddy Current Brake Installation
Version 1 Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
I NSTALLING THE B EARING , S PLINED S HAFT , AND D RIVELINE A SSEMBLY
The eddy current brake can be installed on either side of your dyno, the installation
instructions are the same.
You will need the following parts:
• 22117130 Splined Shaft
• 32355056 Bearing
• 36801080 Bolt, 1/2-13 x 1.5", Flange-Hex (2)
• 62240130 Driveline Assembly
1 Install the bearing using two 1/2-13 x 1.5-inch flange-hex bolts. Leave the bolts
loose.
Figure 4-9: Install the Bearing
EB243
bearing
bolt