Dynojet 424xLC2: Installation Guide - Manual (Page 156)

A P P E N D I X C
Deck Relocation
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C-2
DECK RELOCATION
Before installing the 4WD dyno with an existing 2WD 224 dyno, the deck must be
removed from the stationary dyno to be installed on the 4WD dyno later. The
following instructions will guide you through removing your existing deck and
installing that deck on your 4WD dyno.
R EMOVING THE E ARLY S TYLE D ECK FROM AN E ARLY M ODEL D YNO
This section will guide you through removing the early style deck from an early model
dyno. For instructions on installing this deck to your 4WD dyno, refer to page C-11.
1 Remove the eight 3/8 x 1-inch bolts and eight 3/8-inch lock washers securing the
deck braces to the deck and set aside.
2 Remove the two 3/8 x 1-inch bolts, two 3/8-inch lock washers, two 3/8-inch flat
washers, and two 3/8-inch nuts securing the inside of the outer deck braces to the
deck and set aside.
Figure C-1: Removing the Deck Braces from the Deck
AD104
deck
lock washer
bolt
outer deck brace
nut
flat washer