Dynojet 424xLC2: Installation Guide - Manual (Page 93)

3-51
4 W D D Y N O I N S T A L L A T I O N
Logo Panel Installation
Version 1 Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
LOGO PANEL INSTALLATION
If you did not install the eddy current brakes, you will install four logo panels, two on
the stationary dyno and two on the 4WD dyno using the instructions in this section. If
you installed the eddy current brakes, use the following instructions to install one logo
panel on each dyno. Refer to “Installing the Top and Logo Panel Covers” on page 4-18
to install the logo panel covers on the eddy current brake.
You will need the following parts:
• 21200004 Mounting Bracket (4)
• 21200009 Lower Mounting Bracket (2)
• 36491100 Nut, 7/16-14, Hex, Grade-5 (4)
• 36561045 Screw, 1/4-20 x 5/8", Pan-Head, Torx (10)
• 36591670 Bolt, 7/16-14 x 1", Hex (4)
• 36933100 Washer, 7/16", Flat, Steel (4)
• 61100001 Logo Panel Assembly (2)
• DM150-011-002 Washer, 3/8", Flat (8)
• DM150-019-008 Bolt, 3/8-16 x 3/4", Hex (8)
Repeat the following steps for each logo panel being installed to the dyno.
1 Secure each lower mounting bracket to the dyno using two 7/16-14 x 1-inch hex
bolts, two 7/16-inch flat washers, and two 7/16-14 nuts.
Figure 3-36: Install the Lower Mounting Bracket
A 624 D
lower mounting
bracket