Installing the bridge cover – Dynojet 424xLC2: Installation Guide User Manual
Page 81
Advertising
3-39
4 W D D Y N O I N S T A L L A T I O N
Bridge Installation—Stationary Dyno
Version 1
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
I
NSTALLING
THE
B
RIDGE
C
OVER
1
Remove the center bolt from the rear drum guard.
2
Place the cover on the drum guard while supporting the other end of the cover.
3
Replace the center bolt.
4
Secure the cover to each runner support pillar using two 3/8-16 x 1/2-inch button-
head flange bolts.
Installing the cover will square up the other set of runner assemblies.
5
Tighten all bolts.
Figure 3-26: Install the Center Cover
A 614
D
center bolt
cover
support pillar
cover
Advertising
This manual is related to the following products: