Placing the dyno on the track – Dynojet 424xLC2: Installation Guide User Manual
Page 52
C H A P T E R 3
Dyno Installation
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
3-10
P
LACING
THE
D
YNO
ON
THE
T
RACK
You will need to keep the cable track routed underneath the dyno and towards the
stationary dyno.
You will need the following parts:
• 26152020
Spacer, Rail Clamp (8)
• 36800973
Bolt, Shoulder, 3/8-16, 1/2"D x 1"L (8)
1
Remove the cotter pin and pin from all four cradle assemblies as shown in
Figure 3-5.
2
Verify the rail clamps are positioned as shown in Figure 3-5.
3
Verify the hydraulic movement motor is facing away from the stationary dyno.
4
Using the forklift, gently lower the dyno onto the rails.
Figure 3-5: Lower the Dyno onto the Rails
A 605
D
rail clamp
hydraulic movement
motor facing away
from stationary dyno
cable track under dyno and
towards stationary dyno
rail clamp
cradle
assembly
pin and cotter pin
stationary dyno