Installing the top and logo panel covers – Dynojet 424xLC2: Installation Guide User Manual
Page 114
C H A P T E R 4
Eddy Current Brake Installation
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
4-18
I
NSTALLING
THE
T
OP
AND
L
OGO
P
ANEL
C
OVERS
Note: Before installing the top and logo panel side covers, verify all cables have
been routed and you have completed the 4WD dyno installation. Refer to “Cable
Routing” on page 3-13 for more information.
Repeat these steps for both eddy current brakes.
1
Install the small top cover using four 1/4-20 x 5/8-inch torx flange screws
removed earlier.
2
Install the large top cover using eight 1/4-20 x 5/8-inch torx flange screws
removed earlier.
3
Install the logo panel side cover using six 1/4-20 x 5/8-inch torx flange screws
removed earlier.
Figure 4-18: Install the Top and Logo Panel Covers
AD267
small top cover
logo panel side cover
large top cover