Placing the dyno in front of the lift – Dynojet 424xLC2: Installation Guide User Manual
Page 35
Advertising
2-9
S T A T I O N A R Y D Y N O I N S T A L L A T I O N
Dyno Installation
Version 1
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
P
LACING
THE
D
YNO
IN
F
RONT
OF
THE
L
IFT
1
Verify the interface bracket faces the lift as shown in Figure 2-3.
2
Verify the lift is in the down position.
3
Using the forklift, bring the dyno in front of the lift. The dyno should be about
10.16 cm (4.00 in.) from the lift cross member.
4
Center the dyno drum with the lift runways.
5
Gently lower the dyno into position.
Figure 2-3: Dyno with Lift
lift runway
lift runway
cross member
interface bracket
10.16 cm
(4.00 in.)
Advertising
This manual is related to the following products: