Removing the new style deck from a new model dyno – Dynojet 424xLC2: Installation Guide User Manual
Page 160
Advertising
A P P E N D I X C
Deck Relocation
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C-6
R
EMOVING
THE
N
EW
S
TYLE
D
ECK
FROM
A
N
EW
M
ODEL
D
YNO
This section will guide you through removing the new style deck from a new model
dyno. For instructions on installing this deck to your 4WD dyno, refer to page 3-45.
1
Remove the four 3/8-16 x 3-inch bolts, four flat washers, and four nylock nuts
securing the tube to the outer panels and deck supports and set aside.
2
Remove the tube and set aside.
Figure C-5: Remove the Tube
AD101
tube
Advertising
This manual is related to the following products: