Installing the runner mounts – Dynojet 424xLC2: Installation Guide User Manual
Page 84
Advertising
C H A P T E R 3
Bridge Installation—4WD Dyno
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
3-42
I
NSTALLING
THE
R
UNNER
M
OUNTS
The runner mounts and runner clamps are shorter for the moveable dyno.
1
Place the runner mount (z-shaped) with seven round holes on top of the drum
guard.
2
Place the runner clamp plate with seven round holes on top of the runner mount.
3
Loosely secure each runner mount and runner clamp to the dyno using three
3/8 x 1.5-inch flange hex bolts.
Figure 3-28: Install the Runner Mounts
A 616
D
runner clamp
runner mount
drum guard
Advertising
This manual is related to the following products: