Installing the new style deck on the 4wd dyno – Dynojet 424xLC2: Installation Guide User Manual
Page 169
Advertising
C-15
S T A T I O N A R Y D Y N O U P G R A D E
Deck Relocation
Version 1
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
14 Secure the deck to each deck brace using two 3/8 x 1-inch bolts and two 3/8-inch
lock washers each. Make sure to use one 3/8-inch flat washer and one 3/8-inch
nut on the inside of each outer deck brace.
15 Tighten all deck brace hardware.
Figure C-14: Securing the Deck
I
NSTALLING
THE
N
EW
S
TYLE
D
ECK
ON
THE
4WD D
YNO
Before installing the deck, make sure to complete the 4WD dyno and bridge
installation found in Chapter 3.
Refer to page 3-45 for deck installation instructions.
AD370
nut
flat washer
outer deck brace
lock washer
bolt
Advertising
This manual is related to the following products: