Kontron AM4901 IPMI - Manual (Page 31)

AM5901/AM4901 IPMI Firmware User Guide
ID: 1035-8760, Rev. 3.0 Page 31
fclock-
opts Show currently active FCLKA options
R
spec Select AMC/µTCA specification compliant Fclock e-keying R
rack Select Fclock generated by the backplane. Fclock source for the
slot is always on or switched on by the MCH when PCIe is
active. No clock e-keying for AMC modules. R
manu Select AMC slot specific manual selection of parameters R
manu
<source slot number>
<source slot's Fclock
strategy>
<remote slot number> Enter for one slot with number <Source slot number > (1..6) the
manual parameters <Source Slot's Fclock strategy> (refer to
below) and <Remote slot number> (0..6).
Usage of parameter ‘remote slot number’:
Only if for at least one source slot a 'remote slot number' > 0 is
defined the backplane's clock ptp FRU data will be replaced for
ALL slots by FRU data being defined by all pairs of ‘source slot
number’ and 'remote slot number' parameters.
Remote slot number 0 means no remote slot connected. Each
used remote slot number (except 0) must be unique, i.e. each
source slot may only be connected to one remote slot.
Usage of parameter 'Fclock strategy':
'Fclock strategy' if 'remote slot number' is defined (1..) =
1 = AMC Fclock parameters as specified in FRU data
Use matching ones
2 = AMC Fclock shall be receiver
Copy/modify remote AMC's parameters
3 = AMC Fclock shall be source
Copy/modify remote AMC's parameters.
'Fclock strategy' if no 'remote slot number' is defined (0) =
(AMC shall be source/receiver/fixed, e.g. by switch or default
state)
0 = Do not touch AMC's Fclock
Use AMC's fixed or default state."
1x = AMC Fclock shall be receiver as defined in xth match 0
descriptor
2x = AMC Fclock shall be source as defined in xth match 1
descriptor
R
Table 6: CLI Command List
Command Parameters Description
User
or
Root