Kontron AM4901 IPMI - Manual (Page 43)

AM5901/AM4901 IPMI Firmware User Guide
ID: 1035-8760, Rev. 3.0 Page 43
6.1.1.2 AM4901
The following is a list of the default Common Options for the AM4901 MCH:
locked = 0
suppressRedLEDForEventProcessingError = 0
tempCtrlDevice = 1
processPwrShutdownEvent = 1
phyDevice = 1
prioMode = 0
activConfigMode = 0
pwrMngMode = 0
supprAM4901ErrorBeforeBoardRevR12 = 0
6.1.1.3 AM5901
The following is a list of the default Common Options for the AM5901 MCH:
locked = 0
suppressRedLEDForEventProcessingError = 0
tempCtrlDevice = 1
processPwrShutdownEvent = 1
phyDevice = 2
prioMode = 0
activConfigMode = 0
pwrMngMode = 0
supprAM4901ErrorBeforeBoardRevR12 = 0
6.2 Environmental Options (eopts)
At the first activation of the MCH (Hot Swap switch closed) the Environmental Options are set
automatically to default values corresponding to the type of backplane in the system. The user
can read these options, and if necessary they can be modified with the CLI command “eopts”
or the OEM IPMI commands “CmdGetEnvironOptionsParameter" and "CmdSetEnvironOption-
sParameter". All modifications remain in effect even after resetting or powering-down as long
as when the MCH is re-activated no new board type is recognized or the non-volatile parame-
ters of the MCH are lost.
Manual adaption of the options can be expedient for example in the following case:
• the modified options are to be permanently protected against automatic adaption.
This protection is achieved by setting the options bit 31 (“locked”).
Singular changes of options (bit-wise) is not possible. All Common Options must be read each
time, modified where required, and then re-written.