Kontron AM4901 IPMI - Manual (Page 47)

AM5901/AM4901 IPMI Firmware User Guide
ID: 1035-8760, Rev. 3.0 Page 47
6.2.1 Defaults
Each system has its own set of default values for Environmental Options. For the meaning of
the settings please refer to table 8 "Environmental Options List" above.
6.2.1.1 Backplane Not Recognized or Standard Backplane/Rack
The following is a list of the default Environmental Options for an unknown backplane or a stan-
dard backplane/rack:
locked = 0
fclockMode = 2
pwrChanPlus4IfIs1ForAmc1 = 0
shAddrDevice = 1
ps1EnDevice = 2
clkDevice = 0
pwrDevice = 3
fanDevice = 3
PCI Express communication will work if the required slot-to-slot connections are on the back-
plane. Standard Fclock e-keying is preselected (fclockopts 'spec'). If the Fclock is permanently
supplied by the backplane then fclockopts 'rack' must be selected. Please refer to CLI com-
mand 'fclockopts' and chapter 3.5 E-keying.
6.2.1.2 Backplane Type OM6062 Recognized
The following is a list of the default Environmental Options for the OM6062:
locked = 0
fclockMode = 0
pwrChanPlus4IfIs1ForAmc1 = 0
shAddrDevice = 1
ps1EnDevice = 0
clkDevice = 1
pwrDevice = 1
fanDevice = 1
PCI Express is fully supported because the Fclock is supplied by the backplane. All AMC mod-
ules which require PCIe communications are expected to be an Fclock receiver requiring no
Fclock e-keying. If Fclock e-keying is required, then select fclock mode 'manu' and its param-
eters and refer to CLI command 'fclockopts' and chapter 3.5 E-keying.