Kontron AM4901 IPMI - Manual (Page 34)

IPMI Firmware User Guide AM5901/AM4901
Page 34 ID: 1035-8760, Rev. 3.0
rs [nvparamclear] ‘rs’ resets the MCH (cold reset). The current operating states (M
states) of the AMC boards are not affected.
‘rs nvparamclear’ additionally clears all current configuration
options. To adapt the MCH to its hardware and environment
again you must close the Hot Swap switch or execute a manual
configuration. R
showerror Displays the error variable (hex) and error text in detail UR
showid Display the IDs which were used to identify the MCH hardware
and the backplane.
For the MCH hardware this is the ‘Board Product Name’ in FRU
0 data (MCH’s CM FRU data). For the backplane this is the
‘Board Part Number’ in FRU 253 (Backplane FRU data).
If no FRU data is readable the value ‘Default’ will be displayed. UR
showms Show the current M states for all FRUs in the rack UR
show-
shaddr Display the shelf address being read at MCH start. Please note
that this value will not be refreshed until the next MCH start. UR
slot on|off <num#> Sets the AMC slot with number <num#> = 1… to state AMC
managed / AMC not managed i.e. to state AMC present / AMC
not present.
Note: Only applicable in racks where the presence of AMC mod-
ules is not detected automatically, e.g. in OM6062. In racks
where PS1 signals are available the slot state will be set auto-
matically. R
Displays the present slot state on / off (present / --) of all slots R
sreg rd <Page> <Reg>
<NUM> Eth. Switch Register access read command.
<Page> : Page number
<Reg> : Register offset
<NUM>: Number of bytes to read. R
wr <Page> <Reg>
<Data>* Eth. Switch Register access write command.
<Page> : Page number
<Reg> : Register offset
<Data> : 1 to 8 data byte(s), LS Byte first. R
Table 6: CLI Command List
Command Parameters Description
User
or
Root