Kontron AM4901 IPMI User Manual
Page 33
AM5901/AM4901
IPMI Firmware User Guide
ID: 1035-8760, Rev. 3.0
Page 33
mb
<adr> [<item-to-write>]
Display/change single memory locations
of type
Byte (8 bit)
R
mw
Word (16 bit)
ml
Long (32 bit)
passwd
<new password >
Set a new password as sequence of 5…8 printable ASCII char-
acters. After having set a password you must log in (command
‘login’) before you can use a root only (R) command. If the <new
password> is ‘killpass’ then no current password is defined and
no login is needed to use root (R) commands.
R
prioopts
Shows which priority mode is currently selected (auto or manu
or off). When manu mode is selected the manual parameters are
displayed as well.
R
auto|manu|off
Sets the priority mode for activation and deactivation of the
AMC modules.
auto: Follows the data in the FRU record “MicroTCA Carrier
Activation and Power Management record”.
manu: Use priorities as being defined in the manu parame-
ters below.
off: No priority used. Random sequence is used during
activation and deactivation.
manu
<priority slot 1 (hex)>.
<priority slot 2 (hex)>
…
<priority slot 6 (hex)>
Sets the manual priority mode and the parameter values for
manual mode.
Note: Use the priority values to define the sequence of activa-
tion and deactivation. Slot with priority value 1 will be activated
first and deactivated last.
If Bit 7 of the priority value is set additionally (e.g. 81h for prior-
ity 1) means that this slot will be activated and deactivated ran-
domly.
Example: 1 3 2 4 5 86 activates slot 1 then slot 3 then slot 2 etc.
The deactivation is vice versa. Slot 6 will become activated and
deactivated randomly. The priority setting feature is needed
when e.g. the PCIe End Point AMC module has to be activated
before the Root Complex AMC module but the back plane FRU
data does not support that.
pwr
on|off <num#>
Sets the payload power strategy for the AMC slot with number
<num#> = 1….
on / off means to be powered permanently / automatically.
R
Displays the present state of the slot’s payload power (powered
/ ---) and the selected payload power strategy (permanent /
automatic)
R
Table 6:
CLI Command List
Command
Parameters
Description
User
or
Root