Rice Lake 420 Plus HMI Digital Weight Indicator Installation Manual - Manual (Page 20)

16 420 Plus Installation Manual
3.1.3 Front Panel Configuration
The
420 Plus
indicator can be configured using a series of menus accessed through the indicator front panel when
the indicator is in setup mode. Table 3-1 summarizes the functions of each of the main menus.
Table 3-1. 420 Plus Menu Summary
Menu Menu Function
CONFIG Configuration Configure grads, zero tracking, zero range, motion band, overload, tare function, sample rate,
and digital filtering parameters.
FORMAT Format Set format of primary and secondary units, display rate.
CALIBR Calibration Calibrate indicator. See Section 4.0 on page 30 for calibration procedures.
SERIAL Serial Configure EDP and printer serial ports.
PROGRM Program Set power-up mode, regulatory mode, and consecutive number values.
PFORMT Print Format Set print format used for gross and net tickets. See Section 6.0 on page 39 for more
information.
SETPNT Setpoint Configure Setpoints and digital outputs.
DIG IN Digital Input Assign digital input functions.
ALGOUT Analog Output Configure analog output module. Used only if analog output option is installed.
VERS Version Display installed software version number.
Move UP/
Increrement
VAlue
ENTER value
Move LEFT/
Previous
Move RIGHT/
Next
Move DOWN/
Decrement
Value
Figure 3-2. Front Panel Key Functions in Setup Mode
Four front panel keys are used as directional keys to navigate through the menus in setup mode (see Figure 3-2).
The
UNITS
( ) and
PRINT
( ) keys scroll left and right (horizontally) on the same menu level;
ZERO
( ) and
GROSS/NET
( ) move up and down (vertically) to different menu levels. The
TARE
key ( ) serves as an Enter key
for selecting parameter values within the menus. A label above each of these keys identifies the direction provided
by the key when navigating through the setup menus.
1 st Level
Parameter
Default value Value
When moving thr ough values below the first menu level, press to r etur n to the level
above. Press or to move to the next parameter on the level above
1 st Level
Parameter
2 nd Level
Parameter
2 nd Level
Parameter
Value Value
Figure 3-3. Setup Mode Menu Navigation