Rice Lake 420 Plus HMI Digital Weight Indicator Installation Manual - Manual (Page 30)

SETPNT Menu
Parameter Choices Description
Level 2 submenus
SETPT1
SETPT2

ENABLE
KIND
VALUE
TRIP
BNDVAL Specify settings for setpoint enable, kind, weight value, trip, and band value used by the
setpoint
Level 3 submenus
ENABLE OFF
ON Turn setpoint ON or OFF.
KIND GROSS
NET Specifies the setpoint kind and determines whether function is based on GROSS or NET
weight.
GROSS or NET setpoint kinds can be used.
VALUE number Display and edit the setpoint value
TRIP HIGHER
LOWER
INBAND
OUTBND Trips the setpoint when the weight is higher or lower than the setpoint value, or is within or
outside of the band value. LOWER means the output is active until you reach weight. If trip is
HIGHER, the output is active when the setpoint is met or exceeded. INBAND means the
output is active if the weight is within the band value. If trip is OUTBND, the output is active
when the weight is outside of the band value.
BNDVAL number The band value for either INBAND or OUTBND trip setpoints. BNDVAL is ignored unless trip is
set to INBAND or OUTBND.
HYSTER number Specifies a band around the setpoint value that must be exceeded before the setpoint, once
off, can trip on.
ACCESS OFF
ON Front panel access to setpoints. Specify OFF if setpoints will not be used. ON enables
operator to turn setpoints on/off, change value, or change BANDVAL via front panel entry
during weigh mode.
26 420 Plus Installation Manual
Table 3-7. Setpoint Menu Parameters