Rice Lake 420 Plus HMI Digital Weight Indicator Installation Manual - Manual (Page 41)

Table 5-11. ALGOUT EDP Commands
Command Description Values
SOURCE Analog output source GROSS, NET
OFFSET Zero offset 0%, 20%
ERRACT Error action FULLSC, HOLD, ZEROSC
MIN Minimum value tracked 0–999 999
MINNEG Minimum negative OFF, ON
MAX Maximum value tracked 0–999 999
MAXNEG Maximum negative OFF, ON
TWZERO Zero calibration 0–16 383
TWSPAN Span calibration 0–16 383
420 Plus Installation Manual - EDP Commands 37
5.1.6 Normal Mode Commands
The serial transmit weight data commands (see Table 5-12) transmit data to the EDP port on demand. The SX and
EX commands are valid only in normal operating mode; all other commands are valid in either setup or normal
mode.
Table 5-12. Normal Mode Commands
Command Description Response Format
UID Set unit ID nnnnnnn
SD Set date MMDDYY, DDMMYY, YYMMDD (enter using DATEFMT
specified)
ST Set time hhmm (enter using 24-hour format)
SX Start EDP streaming OK or ??
EX Stop EDP streaming OK or ??
RS Reset system —
XA Transmit accumulator value nnnnnn UU
where nnnnnn is the weight value, UU is the units.
XG Transmit gross weight in displayed units
XN Transmit net weight in displayed units
XT Transmit tare weight in displayed units
XG2 Transmit gross weight in non-displayed units
XN2 Transmit net weight in non-displayed units
XT2 Transmit tare weight in non-displayed units
XW Transmit current piece weight nnnnnn UU
XC Transmit current part count nnnnnn PC
XE Query system error conditions nnnnn nnnnn
See Section 7.1.2 on page 43 for detailed information about
the XE command response format.