Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 1.0 - Manual (Page 63)

Counterpart User Manual - Serial Commands 57
6.1.8 Normal Mode Commands
The normal mode print commands (see Table 6-12) transmit data to the serial port on demand in either setup or
normal mode.
6.1.9 Unique Commands
Command Description Values
CONSNUM#n Set consecutive number 0–9 999 999
UID#n Set unit ID nnnnnnn
SD#n Set date MMDDYY, DDMMYY, YYMMDD, or YYDDMM. Enter
six-digit date using the year-month-day order specified
for the DATEFMT parameter, using only the last two
digits of the year.
ST#n Set time hhmm (enter using 24-hour format)
SX#n Start serial port streaming OK or ??
An EX command sent while in menu mode does not
take effect until the indicator is returned to normal
mode.
The EDP.Stream must be set to LFT or INDUST for this
command to work.
EX#n Stop serial port streaming
XG#n Transmit gross weight in displayed units nnnnnn UU

where nnnnnn is the weight value, UU is the units.
NOTE: You can also send XGP, XGS, XGT, XTP, etc. to
specify primary, secondary or tertiary (P.S.T.).
XN#n Transmit net weight in displayed units
XT#n Transmit tare weight in displayed units
XA#n Transmit accumulator value
RS Reset system Soft reset. Used to reset the indicator without resetting
the configuration to the factory defaults.
Table 6-12. Normal Mode Serial Commands
Command Description
DUMPID.INDEX=n To dump an ID by register
DUMPID.CODE=n To dump an ID by code
Table 6-13. Unique Commands