5 hydraulic assembly, 1 cylinders to line locks – Rice Lake TradeRoute HL Series - Installation and Service Manual (Legal-for-Trade) User Manual
Page 16
12
Trade
Route Installation Manual
2.5
Hydraulic Assembly
Included with each scale module is hydraulic plumbing from the cylinders to the line locks.
2.5.1
Cylinders to Line Locks
A diagram of the hydraulic assembly from the cylinders to the line locks is shown in Figure 2-9.
1. Attach the line locks to the truck frame, using the bolts, nuts, and washers provided. Position the line locks
so there is some slack in the hoses to allow for cylinder motion.
2. Thread orifices into the lower ports of the cylinders. This is an ORB (SAE) o-ring fitting. Ensure the o-ring
is on the fitting.
3. Thread fittings into the upper port of the cylinders. These fittings do NOT have an orifice. Ensure the
o-ring is on the fitting.
4. Thread hoses into the C1 & C2 ports of the line locks.
5. Thread hoses into the fittings on the cylinders.
Cylinder
PN 127183
Adapter
PN 128242
Allow Some
Slack in Hoses
Hoses
PN 127607
Line Lock
PN 127083
Oriface
PN 128286
Figure 2-10. Assembly of Hydraulic Components