13 920i indicator junction box cable installation, Trade, Figure 2-23. junction box indicator terminal – Rice Lake TradeRoute HL Series - Installation and Service Manual (Legal-for-Trade) User Manual
Page 26: Figure 2-24. single-channel a/d card
JP4
JP 2
PT4
PT3
JP3
PT1
EXP
PT2
JP1
1
CELL4
1
CELL1
1
CELL3
1
CELL2
IND
-EX
-SI
SHD
+SI
+EX
M
R
N
I
-SI
S2 C
I
A
G
+EX
+SI
-SI
SHD
-EX
I
S
G
A
L
T
+SI
M
S
I
N
L
T
R
+EX
-EX
-SI
SHD
+SI
+EX
+SI
-EX
-SI
SHD
-EX
SHD
+SE
-SE
+EX
22
Trade
Route Installation Manual
Figure 2-23. Junction Box Indicator Terminal
2.13 920i Indicator Junction Box Cable Installation
The homerun cable has been installed by the factory. If required, attach cable from a junction box to an installed A/
D card, route the cable through the cord grip and ground the shield wire.
Next, remove connector J1 from the A/D card. The connector plugs into a header on the A/D card (see
Figure 2-23). Wire the load cell cable from the load cell or junction box to connector J1 as shown in Table 2-2.
SIG+
SIG–
SEN+
SEN–
EXC+
EXC–
J1
JP2
JP1
Figure 2-24. Single-Channel A/D Card
If using six-wire load cell cable (with sense wires), remove jumpers JP1 and JP2 before reinstalling connector J1.
For four-wire installation, leave jumpers JP1 and JP2 on. For six-wire load cell connections on dual-channel A/D
cards, remove jumpers JP3 and JP4 for connections to J2.