Talkaphone WEBS-PA-2IP Outdoor Area WEBS Paging Unit - Manual (Page 10)

WEBS-CM-2, WEBS-PA-1 and WEBS-PA-2
Configuration and Operation Manual
Page 10 of 53
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4. Using the Web GUI
This section describes various configurable options available from the Web Interface of the communications
module. It is the primary interface for configuring and monitoring the communications module. You must
assign an IP address (Refer to 4.4.1 IP Settings) before configuring the features of the communications
module.
4.1. Web GUI Layout
This section describes the layout of the Web GUI.
Figure 2 Using Web GUI
The Web GUI layout is divided into four sections:
1. Header: The Header section displays Talk-A-Phone Logo and product title “Communications Module”. The
right side of the header has the Refresh, Help, and Logout buttons. The Refresh button is used to reload
the content section. The Help button provides help content from the Talk-A-Phone website. The Logout
button logs out the user. The Apply button will not be grayed out if the content pane (3) contains
configurable parameters. The Apply button is used to save configuration changes to communications
module.
1
3b
2
3a
4
3c