Talkaphone WEBS-PA-2IP Outdoor Area WEBS Paging Unit - Manual (Page 50)

WEBS-CM-2, WEBS-PA-1 and WEBS-PA-2
Configuration and Operation Manual
Page 50 of 53
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
++ Description : Admin can configure Led3 to switch on when remote user
++ enters specific key sequence.
++ Valid values : Max 8 chars containing 0-9, * and #.
++ Default is *98*
++ Note : None
++
++ Field name : Led3DurationType
++ Description : Admin can configure Led3 duration of activation.
++ Valid values : Led3Duration = 1 - For Entire Call (Default Value)
++ Led3Duration = 2 - For indefinite duration
++ Led3Duration = 3 - For Custom duration
++ Note : If Led3Duration = 3 then configure duration time.
++
++ Field name : Led3Duration
++ Valid values : 1 - 3600 sec,in increments of 1 sec. 10 (Default Value)
++
++ Field name : Led3SwitchOff
++ Description : Admin can configure key sequence to switch off when remote
++ Admin enters specific key sequence.
++ Valid values : Max 8 chars containing 0-9, * and #.
++ Default is *97*
++ Note : None
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Led3 = 3
Led3SwitchOn = *98*
Led3DurationType = 1
Led3Duration = 10
Led3SwitchOff = *97*
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++ Field name : GuardAccessCode
++ Description : Admin can set the guard access code using this field.
++ Valid values : Maximum length 8 digits(0-9).
++ GuardAccessCode = *4** (Default Guard access code)
++ It will accept the values in the following format.
++ *4*<xxxxxxxx>* , x can be 0-9 or blank
++ Note : None
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
GuardAccessCode = *4**
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++ Field name : AuthVolAdjust , AuthSpkrMicCtrl, AuthVoiceMessage ,
++ AuthAuxOPOperation , AuthLED3Operation
++ Description : Admin can configure the authetication for different
++ operations.
++ a. Volume Adjustment During Call
++ b. Speaker and Microphone Control During Call
++ c. Voice Messages
++ d. Aux o/p Activation Deactivation
++ e. Help on the way LED activation and deactivation
++ Valid values : 0 - To disable Authentication
++ 1 - To enable Authentication
++ Note : None