Webs-cm-2, webs-pa-1 and webs-pa-2, Configuration and operation manual – Talkaphone WEBS-PA-2IP Outdoor Area WEBS Paging Unit User Manual
Page 27
WEBS-CM-2, WEBS-PA-1 and WEBS-PA-2
Configuration and Operation Manual
Page 27 of 53
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected]• www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4.7.9. Reset to Defaults
The Reset to Defaults page allows the communications module configuration parameters to be set to their
default values. It also provides an option to retain the IP address and/or the username and password.
Login → Maintenance → Reset to Defaults
Figure 31 Reset to Defaults
To reset to defaults:
1.
Select Network IP Address, if the IP address of the communications module needs to be retained. If this
option is not selected the IP address of the communications module will default to 192.168.1.10.
2.
Select Username and Password if the Web Interface credentials need to be retained. If the option is not
selected the username will default to admin and the password will default to admin@123.
3.
Select SIP if the SIP settings need to be retained. If this option is not selected the SIP Settings will be
deleted.
4.
Click Apply. The communications module automatically reboots with the default settings.
4
3
1
2
3