Webs-cm-2, webs-pa-1 and webs-pa-2, Configuration and operation manual – Talkaphone WEBS-PA-2IP Outdoor Area WEBS Paging Unit User Manual
Page 15
WEBS-CM-2, WEBS-PA-1 and WEBS-PA-2
Configuration and Operation Manual
Page 15 of 53
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected]• www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4.5. VoIP
4.5.1. Paging Settings
The communications module can be used as a paging device by a WEBS Contact® Server. The page can be
output through either the built-in hands-free speaker or the line level output, depending on the specific device.
Login → VoIP → Paging Settings
Figure 11 Paging Settings
To configure paging settings:
1.
Select Speaker or Line Level Output to send the incoming audio page to the built-in hands-free speaker
or the line level output. The speaker option is only available for the WEBS-PA-1.
2.
Click the drop-down menu to adjust the Output Gain for all incoming pages before sending to the selected
audio paging output. Each level adjustment corresponds to approximately 3dB.
3.
The communications module displays Unregistered or Registered @
<WEBS_Contact_Server_IP_Address> for Registration Status on the WEBS Contact® Server.
4.
If it deregistration is required from the WEBS Contact® Server in error situations where the WEBS
Contact® Server is unable to deregister the device, select Deregister check box to clear the registration
status.
5.
Click Apply to save settings.
1
2
5
4
3
4