Webs-cm-2, webs-pa-1 and webs-pa-2, Configuration and operation manual – Talkaphone WEBS-PA-2IP Outdoor Area WEBS Paging Unit User Manual
Page 49
WEBS-CM-2, WEBS-PA-1 and WEBS-PA-2
Configuration and Operation Manual
Page 49 of 53
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected]• www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
VM5PlayToGuardOnRemoteKeyCode = Disable
VM5StopToGuardOnRemoteKeyCode= Disable
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++ Field name : VM1PlayToGuardInLoop
++
++ Description : The VM #1 will be played to the guard in loop
++
++ Valid values : 0 - 1
++ 0- Disable, the VM play in loop
++ 1- Enable, the VM play in loop
++
++ VM1PlayToGuardInLoop = 0 (Default value)
++
++ Note : Admin can similarly program values for VM #2 to VM #5
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
VM1PlayToGuardInLoop = 0
VM2PlayToGuardInLoop = 0
VM3PlayToGuardInLoop = 0
VM4PlayToGuardInLoop = 0
VM5PlayToGuardInLoop = 0
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++ Field name : KeypadMode
++ Description : Mode of keypad to be used for dialing.
++ Valid values : KeypadMode = 1 - Normal dial (Default Value)
++ KeypadMode = 2 - Speed dial
++ Note : If Keypad is in speed dial, then Admin should configure
++ the speeddial numbers (Max 30 chars) .
++ Admin can configure IP Addresses, Analog Numbers, Aliases
++ and URLs. (Max 30 chars)
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
KeypadMode = 1
SpeedDialKey0 =
SpeedDialKey1 =
SpeedDialKey2 =
SpeedDialKey3 =
SpeedDialKey4 =
SpeedDialKey5 =
SpeedDialKey6 =
SpeedDialKey7 =
SpeedDialKey8 =
SpeedDialKey9 =
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++ Field name : Led3
++ Description : Admin can configure Led3 Mode for specific purposes
++ Valid values : Led3 = 1 - Help on The Way
++ Led3 = 2 - Out Of Service
++
++ Note : For Options 1 and 3, Configure following parameters
++
++ Field name : Led3SwitchOn