Dynon Avionics D100 Series to SkyView Conversion Guide - Manual (Page 12)

D10 and D100 Series Conversion To SkyView Guide – Rev D Page 12
SkyView Incompatibilities with Dynon Avionics EFIS and EMS Systems
SkyView is not compatible with the following Dynon accessories that may be part of a Dynon
Avionics EFIS or EMS system:
AP74 – SkyView does not support the AP74 Autopilot Control Panel. SkyView has eight
pushbuttons and two knobs / joysticks, so Autopilot control is as easy with SkyView as it is with
the AP74. For example, the heading bug can easily be adjusted via a knob twist, which on a
Dynon Avionics EFIS required the installation of an AP74 or HS34.
EDC-D10A – SkyView does not use the EDC-D10A. In SkyView, the magnetic heading sensor is
integrated into the SV-ADAHRS-200/201.
EFIS Wiring Harness – SkyView does not use the same EFIS 25-pin “Primary Wiring Harness” as
the Dynon Avionics EFIS.
HS34 – SkyView does not support the HS34 HSI Expansion Module. For ARINC-429 functions of
the HS34, SkyView uses the SV-ARINC-429 module. For serial port connections to the HS34, use
the serial port inputs and serial port outputs on the SkyView display(s). The functionality of the
knobs and buttons on the HS34 are integrated into the SkyView display.
The Analog Resolver, DME, Marker, etc. inputs and outputs present on the HS34 are not
available in SkyView.
Internal Li-Ion Backup Battery – SkyView is not compatible with the (internal) backup battery
used in Dynon Avionics EFIS units. SkyView displays use a completely different, external backup
battery (SV-BAT-320).
OAT Probe for EDC-D10A (older) – SkyView is not compatible with the Dynon 100240-000 OAT
(Type 1, no black band on the cable). This OAT probe has not been sold since 2004.
Mounting Trays – SkyView does not use mounting trays
13
, so after removing the Dynon
Avionics EFIS and/or EMS, remove any mounting trays, including the mounting trays for the
AP74 and HS34.
13
Exception – SV-XPNDR-261/262 has a mounting tray.