Dynon Avionics D100 Series to SkyView Conversion Guide - Manual (Page 19)

D10 and D100 Series Conversion To SkyView Guide – Rev D Page 19
Guidelines for Connection of Installed OAT to SV-ADAHRS-200/201 OAT Input
It is possible to convert an already-installed Dynon OAT probe that was previously connected to
the EDC-D10A, to a SkyView SV-ADAHRS-200 or SV-ADAHRS-201. Instructions for this
conversion are in the SkyView System Installation Guide, Chapter 5 – SV-ADAHRS-20X
Installation and Configuration, in the section Dynon D10/D100 Series OAT Probes.
Guidelines for Conversion of EMS Main Sensor Harness to
SkyView SV-EMS-220 Main Sensor Harness
For a detailed explanation of the full range of capabilities for each pin of the SV-EMS-220 37-pin
connector, see these tables and figures in the SkyView System Installation Guide, SV-EMS-220
Installation and Configuration:
● Sensor and Transducer Compatibility Level Key
● SV-EMS-220 Male D37 Pin-to-Sensor Compatibility
● SV-EMS-220 37-pin Main Sensor Harness Female D37 Pin Insertion View (Rear)