Dynon Avionics D100 Series to SkyView Conversion Guide - Manual (Page 43)

D10 and D100 Series Conversion To SkyView Guide – Rev D Page 43
Guidelines for Conversion of Dynon Avionics Autopilot Servos
The primary change for a servo converting to SkyView is that the servo’s White/Blue and
White/Green wires (unused in Dynon Avionics EFIS systems) now need to be brought forward
to connect to the SkyView Network along with the Blue and Green wires that previously
connected to the EFIS and EMS DSAB network.
Note: To connect to SkyView, Autopilot servos must have a (EFIS) firmware version installed of
at least v5.2. If the servo does not have at least v5.2, it will not be able to communicate with
SkyView. If your EFIS unit (which updates the Autopilot servos) does not have at least v5.2:

Update your Dynon Avionics EFIS (including the Autopilot servos) to the most current
version prior to removing it from the plane, or

Contact Dynon Technical Support to arrange a Return Material Authorization (RMA) to
ship your Autopilot servos to Dynon for a firmware update.
Servo Wire
Color
Servo Wire Function Notes for conversion to SkyView System
Black GROUND No change required.
Red POWER No change required.
Yellow SERVO DISCONNECT No change required.
Green
SKYVIEW NETWORK
DATA 1A Must be connected to SkyView Network (optionally, via SkyView
Network Hub) on Pin 1 of SkyView Network 9-pin connector.
Blue
SKYVIEW NETWORK
DATA 1B Must be connected to SkyView Network (optionally, via SkyView
Network Hub) on Pin 6 of SkyView Network 9-pin connector.
White/Green
SKYVIEW NETWORK
DATA 2A Must be connected to SkyView Network (optionally, via SkyView
Network Hub) on Pin 8 of SkyView Network 9-pin connector.
White/Blue
SKYVIEW NETWORK
DATA 2B Must be connected to SkyView Network (optionally, via SkyView
Network Hub) on Pin 4 of SkyView Network 9-pin connector.