Dynon Avionics D100 Series to SkyView Conversion Guide - Manual (Page 17)

D10 and D100 Series Conversion To SkyView Guide – Rev D Page 17
EFIS D25
Female
Connector
Pin No. EFIS D25
Connector
Wire
Color
EFIS Function Notes for conversion to SkyView SV-HARNESS-D37
10 ORANGE SERIAL 1 – TX
If this wire was used for connection to PC, no longer
required; remove this wire.
If this wire was used for connection to GPS or NAV
radio, reroute this wire to SkyView Display Serial Port
TX.
If this wire was used for EFIS Streaming Data, reroute
this wire to SkyView Display Serial Port TX.
11
WHITE /
ORANGE
EDC-D10A DATA B
Not used in SkyView system.
Remove this wire.
12
WHITE /
BLUE
EDC-D10A POWER
Not used in SkyView system.
Remove this wire.
13
BLUE /
WHITE
SERIAL 2 TX
If this wire was used for transponder (or Dynon
100362-000 Serial-to-Gray Code Encoder Converter
Module), reroute this wire to SkyView Display Serial
Port TX.
14 This pin is not used, and thus not populated in the EFIS Connector – no wire.
15
No wire
(in Dynon
harness)
EXTERNAL BACKUP
POWER
A single power wire (typically 22 AWG) used for power
to a Dynon Avionics EFIS is inadequate for a (and
especially multiple) SkyView display(s).
Not used in SkyView system.
Remove this wire.
16 BLACK (UNUSED) / GND
If this wire was used for Ground to an external device,
connect to Master Ground, common with SV-
HARNESS-D37 black wires on Pins 21 & 22
17 This pin is not used, and thus not populated in the EFIS Connector – no wire.
18 GREEN AUDIO OUT
If this wire was used for audio output, reroute this
wire to SkyView display. Because EFIS Audio was
mono, connect this wire to both SkyView Display
PIN 13 – AUDIO OUTPUT LEFT
and
PIN 31 – AUDIO OUTPUT RIGHT
If a 10K potentiometer was installed on this to adjust
volume, remove it (SkyView has internal volume
adjustment).
19, 20 These pins are not used, and thus not populated in the EFIS Connector – no wires.