Dynon Avionics D100 Series to SkyView Conversion Guide - Manual (Page 32)

D10 and D100 Series Conversion To SkyView Guide – Rev D Page 32
EMS-D10 / EMS-D120 / FlightDEK-D180 Sensor Type
Description in Manual SkyView Sensor Description
SENSOR INPUT MAPPING
Oil Pressure – Type 1
Dynon P/N 100411-002
Rotax 912 pre-installed (prior to mid-2008)
Check to see the type of sensor is actually installed on
the engine:
0-150 PSI FLUID PRESSURE (100411-002) or
ROTAX OIL PRESSURE (MECHANICAL)
Oil Pressure – Type 2
GRT HPS-01
0-150 PSI FLUID PRESSURE (100411-002)
Oil Pressure – Type 3
Jabiru pre-installed
JABIRU OIL PRESSURE
Oil Pressure – Type 4
Rotax P/N 956413 (mid-2008 and later)
ROTAX OIL PRESSURE (HONEYWELL)
Oil Pressure – Type 5
Dynon P/N 101693-000 – Kavlico 150 PSI
KAVLICO 150PSI FLUID PRESS (101693-000)
Oil Temperature – Type 1
Dynon P/N 100409-001
1/8”-27 NPT FLUID TEMP (100409-001) or
5/8”-18 NPT FLUID TEMP (100409-000)
SkyView bug - see which one works
Oil Temperature – Type 2
Dynon P/N 100409-000
1/8”-27 NPT FLUID TEMP (100409-001) or
5/8”-18 NPT FLUID TEMP (100409-000)
SkyView bug - see which one works
Oil Temperature – Type 3
GRT FC-LC-01
GRT OIL TEMPERATURE (FT-LC-01)
Oil Temperature – Type 4
Rotax pre-installed
ROTAX CHT OR OIL (801-10-1)
Oil Temperature – Type 5
Jabiru pre-installed
JABIRU OIL TEMP
Oil Temperature – Type 6
Chevrolet LS7 pre-installed
This sensor is not supported in SkyView
Oil Temperature – Type 7
MGL 2-wire
This sensor is not supported in SkyView
Oil Temperature – Type 8
MS28034-3 2 wire
MS28034-3 Engine Temperature Sensor
Oil Temperature – Type 9
Westach 399S7 (1/8-27 NPT)
Westach 299S9 – (5/8-18 UNF)
These sensors are not supported in SkyView