Dynon Avionics D100 Series to SkyView Conversion Guide User Manual
Page 36
D10 and D100 Series Conversion To SkyView Guide – Rev D
Page 36
HS34
Male
Connector
Pin No.
HS34 Male Connector
Function
Notes for conversion to
SV-HARNESS-D37
and
SV-EMS-220 Main Sensor Harness
13
GP 3 in (Same as EMS
GP in)
Reroute this wire to an available General Purpose Input Pin on SV-EMS-
220 Main Sensor Harness:
Pin 4 Violet/Blue GENERAL PURPOSE INPUT 1 (TYPE A)
Pin 6 White/Yellow GENERAL PURPOSE INPUT 11 (TYPE B)
Pin 7 White/Brown GENERAL PURPOSE INPUT 12 (TYPE A)
Pin 8 Brown ENHANCED GENERAL PURPOSE INPUT 4 (TYPE C)
Pin 9 Brown/Blue GENERAL PURPOSE INPUT 5 (TYPE A)
Pin 10 Brown/Yellow GENERAL PURPOSE INPUT 6 (TYPE A)
Pin 11 Orange GENERAL PURPOSE INPUT 7 (TYPE A)
Pin 12 Yellow GENERAL PURPOSE INPUT 8 (TYPE A)
Pin 20 Orange/Brown GENERAL PURPOSE INPUT 9 (TYPE A)
Pin 21 Orange/Blue GENERAL PURPOSE INPUT 10 (TYPE A)
Pin 22 Violet/Yellow ENHANCED GENERAL PURPOSE INPUT 2 (TYPE C)
Pin 23 Violet/Green GENERAL PURPOSE INPUT 3 (TYPE C)
Pin 31 White/Orange ENHANCED GENERAL PURPOSE INPUT 13 (TYPE C)
If this wire was used for Dynon P/N 100413-000 Carb Temp Sensor,
remove the 1K resistor installed between this pin and Pin 9 (+5V OUT).
If this wire was used for Dynon 100411-000 Pressure Sensor for
monitoring coolant, remove the 1K resistor installed between this pin
and Pin 9 (+5V OUT).
If this wire was used for Dynon 100409-000 or 100409-001 Oil / Coolant
Temp Sensor for monitoring coolant, remove the 1K resistor installed
between this pin and Pin 9 (+5V OUT).
If this wire was used for Rotax CHT, remove the 1.21K resistor between
this pin and Pin 9 (+5V OUT).
If this wire was used for Dynon 100433-000 OAT, see Guidelines For
Connection of Installed OAT to SV-ADAHRS-200/201 OAT Input.
14
SERIAL 1 TX
If this wire was used for connection to PC, no longer required; remove
this wire.
If this wire was used for connection to GPS or NAV radio, reroute this
wire to SkyView Display Serial Port TX.
15
SERIAL 2 TX
If this wire was used for connection to GPS or NAV radio, reroute this
wire to SkyView Display Serial Port TX.
16
DSAB B
Not used in SkyView system.
Remove this wire.