Acoustica Mixcraft 7 - Manual (Page 130)

124
Be a Loop Mode Ninja!
A faster way to set
loop points is to drag a
purple highlight area
either in the Timeline
or Main Clip Grid, then
click the Loop button.
This automatically sets
the in and out points to
the beginning and end
of the highlight region.
(You can also use the
L key shortcut to toggle
loop mode on and off.)
Remember that the
Snap setting affects
where the loop region
markers land; we
recommend setting
this to Snap To Grid
or Bar for more
congruent clips.
To create a loop, click the Loops mode button in the Transport, then drag the Loop
Start and Loop End markers in the Timeline to set a loop area.
 Punch In/Out
Punch In/Out recording lets place markers define where to start and end
recording.
To mark a region for punch in/out recording,
click the Punch In/Out button.
Set the Punch In and Punch Out handles in the Timeline.
After setting up a punch area, press record, and the new recordings will be created
inside the punch start and end.
You can use the same technique described in the “Loop Mode Ninja” sidebar
for setting Punch In/Out locations.