Acoustica Mixcraft 7 User Manual
Page 66
60
CLIP-BASED AUTOMATION
Each audio clip has its own independent automation line for the following parameters:
Volume
Low Pass Resonance
Pan
High Pass Cutoff
Low Pass Cutoff
High Pass Resonance
These are all simultaneously available for any clip. To select the currently displayed
automation line, highlight a clip, or clips, and select the parameter in the Main
Window Toolbar at the top of the screen.
Note: Clip Automation, where automation is applied to clips individually, is separate
from Lane Automation, where automation affects an entire track in a continuous line.
Both types of automation work simultaneously, so be aware of this if you’re
using both types on the same content.
Here we’ll adjust clip volume.The clip automation display selector (that’s a mouthful)
switches the parameter displayed globally for all clips in a project.
Adjusting Clip Automation
To create and adjust clip automation points, hover the mouse cursor over the lower
section of a clip. The clip’s automation line will appear, and the cursor will turn into
crosshairs. Click to create new points, and drag to position them.