ANKOM TDF Dietary - Manual (Page 13)

Operator’s Manual
Rev E 12/2/14
pg. 13
1 – Amylase/AMG Container assy (TDF57)
(ONLY with AOAC 2009.01/2011.25 methods)
1 – Trizma Container assy (TDF58)
(ONLY with AOAC 2009.01/2011.25 methods)
1 – Maleate Buffer Container assy (TDF39) &
Fluid Tube Label
(ONLY with AOAC 2009.01/2011.25 methods)
1 - Enzyme Pinch Bar (8167) 1 - Spray Tip Cleaning Tool (8130)
3. Place the Waste Tray under the front of the instrument.
With the Drain Tube connector pointing away from you, slide the tray under the front of the instrument until it cannot go
back any farther. (When the tray is in place, the side ridges will contact the front face of the steel frame.)
4. Place the six Filtrate Cups on the Waste Tray if you want to capture the SDF filtrate.
5. Connect the Drain Tube to the Waste Tray.
Connect and secure the Drain Tube to the Waste Tray using the supplied Drain Tube Clamp. Run it to either a drain or a
waste container, avoiding twists in the tube. If necessary cut the Drain Tube and use the Elbow Connectors to meet the
needs of your location.
6. Connect the Chemical Container Holders to the feet of the instrument.
Remove the nuts from the outside of the left and right feet of the instrument. Slide the single container holder onto the
bolts on the left foot and the three container holder onto the bolts on the right foot. Secure the holders using the nuts.
Bolts to attach the
three container holder
Bolts to attach the
single container holder
Elbow Connector
Drain Tube Clamp