Aviom Pro64 Network Manager - Manual (Page 35)

26 P
ro
64 N
etwork
M
aNager
U
ser
g
Uide
Circuit Board DIP Switches on the 6416Y2
Before installing the 6416Y2 card in the Yamaha device, set up the card’s DIP switches as follows so that the
card’s firmware can be updated:
Set DIP switch #1 in block SW8 in the down position —this sets the card to 1.
communicate via RS‑232.
Set the card for
2. Managed Mode by moving DIP switch #10 found in Switch Block 9
(SW9) to the up position.
In order to properly communicate with Pro64 Network Manager during a
3. firmware
update, all Virtual Data Cables on the 6416Y2 card need to be disabled. To do this,
set DIP switches 2 through 7 found in Switch Block 8 (SW8) to the down position.
In Switch Block SW4, set switches 2, 5, and 8 to the up position —this sets the
4. baud
rate, stop bit, and parity for the RS‑232 communication with the PC.
The MY Mode switch (SW8, #10) can be in either position; it is shown in the 16‑channel MY16 Mode (up) in
the diagrams.
DIP switches used for the Slot Transmit and Receive ranges (#5‑8 in block SW9) can be ignored during the
update process; they are shown in the down position in the diagrams that follow. Channel activation DIP
switches found in DIP Switch Blocks SW1 and SW2 are also ignored during a firmware update. Those are
also shown as off (down) in the diagram.
Once the DIP switches are set, the card can be installed in the Yamaha host device.
ON
ON
ON
ON
ON
ON
SW7
SW8
SW3
SW9
SW4
SW1
SW2
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
Managed Mode (up)
Baud Rate
MY 16 Mode
RS-232 (down)
The 6416Y2 card ready for a firmware update (DIP switch handles are black)