Aviom Pro64 Network Manager - Manual (Page 86)

77 P
ro
64 N
etwork
M
aNager
U
ser
g
Uide
AllFrame Standby Options
AllFrame devices in a network can be placed into standby and remain on the network while I/O cards
are changed. Three versions of standby are supported: software controlled from the AllFrame’s Device
Window, from the AllFrame hardware’s front panel Standby momentary switch, or by using a wired contact
closure connected to the Standby Euroblock connector on the top panel on the unit.
Standby informations appears in the Device Window’s Overview.
When an AllFrame is in standby its Status icon in the Network Overview will be displayed in gray. Changes
to routing, mic preamp settings, output levels, etc., can still be made but will not be available until the
AllFrame is out of standby.
The AllFrame’s Status icon in the Network Overview is gray when the device is in Standby.